COMPANION Meridian Mail Guia de Instalação descarregar pdf (Página 37)

Hardware installation 1-17

Replacing the disk drive

Standard 2.0 Meridian Mail Mini and Enhanced Card Option May 2000

Installation and Maintenance Guide

Replacing the disk drive

Introduction

If the disk drive fails and needs to be replaced, use this

procedure.

Installing the disk

drive (NTDK74AB)

To install the disk drive, follow these steps

At startup, the green LED lights up for about a half-second and

then goes off. After the internal hardware diagnostics are

complete, this green LED stays on if all of the Mail CPU Card

hardware passes its test. A flashing green LED indicates that

some hardware is in faulty condition. Typically, this fault can be

cleared away by tightening the connection of the SCSI drive

and/or the hard disk drive, or by replacing the hard disk drive, if

necessary. The amber LED (HDD) lights whenever the hard

disk drive is being accessed.

Step Action

1 Connect one end of the LED Jumper supplied to the J12

connector on the board, (the black wire is connected to

the side marked with a dot (negative) of the J12

connector).

2 Connect the other end to the hard disk drive remote LED

connection. For example, on ST34520N, the red wire

(positive) goes to pin 11, and the black wire (negative or

cathode) goes to pin 12.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 261 262

Sem comentários

COMPANION Meridian Mail Guia de Instalação Página 37